Smoke control units for residential buildings

System for multi-family dwellings covered by the decree of January 31, 1986 (dwellings and sheltered housing not exceeding 50m to the floor of the top floor, and their covered parking lots if over 100m²).

• Manages up to 2 townships of 20 floors each;
• 72W of power available for both cantons + 12W for carry-over ;
• Joint floors can be configured ;
• Modbus RTU output for connection to a supervision system ;
• Automatic smoke extraction on one floor at a time to prevent smoke from spreading through ventilation ducts;
• Possibility of connecting manual fire releases and sound diffusers for use in residential homes (article 69 of the decree of 31/01/1986);
• Arkeon application for diagnostic and installation assistance.

Installers

• Simple, cable-saving system architecture
• Space-saving, easy-to-install equipment (no drilling of enclosures, screwing onto fixings outside the modules);
• Auto-detection and auto-configuration of the control unit, easy configuration of options 
• Wiring instructions directly on the equipment ;
• Detailed status of wiring and any errors, faults or alarms via LEDs near each terminal block;
• Indicators visible without opening the modules ;
• Resistance of modules to short circuits, wiring errors and reverse polarity ;
• A floor can be put into or out of test mode from its module;
• Fault and alarm history, detailed status of each module and power bus current measurements via the Arkeon mobile application;
• No specific modules for shutter connection or end of line (end of line element only);
• 24 or 48V module operation ;
• Buses and modules protected by self-resetting electronic fuses (a single physical fuse at the mains input) ;
• Monitoring of all lines (DM, detectors, position sensors, smoke extraction dampers, etc.);
• Periodic integrity check of firmware and site data.

Maintainers

• Fault and alarm history (1024 events), detailed status of each module and power bus current measurements via the Arkeon mobile application;
• Detailed status of wiring and any errors, faults or alarms via LEDs near each terminal block;
• Indicators visible without opening the modules ;
• A floor can be put into or out of test mode from its module;
• Buses and modules protected by self-resetting electronic fuses (a single physical fuse at the mains input) ;
• Monitoring of all lines (DM, detectors, position sensors, smoke extraction dampers, etc.);
• Periodic integrity check of firmware and site data.

Users and security services

• Simplified front panel with immediate display of important information;
• Fault and alarm history, detailed status of each module and power bus current measurements via the Arkeon mobile application;
• Monitoring of all lines (DM, detectors, position sensors, smoke extraction dampers, etc.);
• Periodic integrity check of firmware and site data.